Water cooled Spindle + Inverter , Custom add potentionmeter

Just got Water cooled spindle + Inverter + Spindle clamp. So today i do wiring and add Potentiometer to Inverter and then test them to make sure everything work fine and correct wiring.

Item arrive ::

iD2CNC_SpindleInverter (1)

 

Unpack the packageiD2CNC_SpindleInverter (2)

 

Start wiring ::

iD2CNC_SpindleInverter (3) iD2CNC_SpindleInverter (4) iD2CNC_SpindleInverter (5) iD2CNC_SpindleInverter (6) iD2CNC_SpindleInverter (7) iD2CNC_SpindleInverter (8)

 

Note :: For single phase power use “R” and “T” but for Three phase power use “R” and “S” , or “S” and “T” , both will work fine.

After finish wiring then test run ::

iD2CNC_SpindleInverter (9) iD2CNC_SpindleInverter (10) iD2CNC_SpindleInverter (11)

 

Note :: Before start run it VFD need to parameter setting.

– PD005 = 400 (Hz)

-PD004 = 400 (hz)

– PD003 = 400 (hz)

– PD008 = 220 (220volt)

– PD072  = 400 (hz)

– PD144 = 3000

This parameter need to set up before start run spindle. Other parameter see document.

After test , It work correctly and everything good so next i need to add potentionmeter to font panel of inverter , it already have socket for putting potentionmeter into it.

iD2CNC_SpindleInverter (12) iD2CNC_SpindleInverter (13) iD2CNC_SpindleInverter (14) iD2CNC_SpindleInverter (15) iD2CNC_SpindleInverter (16) iD2CNC_SpindleInverter (17) iD2CNC_SpindleInverter (18) iD2CNC_SpindleInverter (19) iD2CNC_SpindleInverter (20) iD2CNC_SpindleInverter (21) iD2CNC_SpindleInverter (22) iD2CNC_SpindleInverter (23)

Done !!!  lol

Video test here ::

 

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s