Time to start build my CNPC (CNC + PC) ,just have little time to cut acrylic and aluminium profile but still have many thing to do. Not much description but a lot of pictures.
Part II
A little update with DB25 breakout board mounting.
Part III
Today i just go to shopping ,so not much thing i can finish, a little update.
Shopping ::
Redesign and fix some cosmetic issued ::
Aluminium PC Card slot mounting ::
SSD mounting and Switching PSU mounting ::
80mm Fan Grill (80x160mm) ::
Other components ::
Part IV
A little update with PC Card Slot Cover.
PC Card Slot Cover ::
Part V
Back to my work, try to test assembly case to prove that everything fit together but still need to drill and tap top panel and right panel i think i’ll finish top and right panel soon.
Test assembly
Top and Right panel design
Part V
Just finish cutting right panel and finish drill ,taps top panel and next step i’ll do spray paint.
Right Panel Work
Top and Right panel
Part VI
Update finish right and top panel, and start assembly.
Right and Top Panel work
Part VII
Update , Assembly PC.
Assembly
one of my problem when assembly this case that 4pin PC PSU is to short , i need to extend 4pin wire to connect to motherboard.
Part VIII
OK, Start to wiring and put some stuff to case.
Wiring
Part IX
Still working with wiring everything together
80% Finish wiring
My CNPC vs Standard case
Next job
This my next job to use this resistor to reduce 12v to 8v , to make fan quiet. Actually i need to use PC Fan Control it can adjust voltage but it expensive so i decide to invest with this resistor it very cheap.
Part X
Back to work !!!. For a couple week ago i don’t have time to work with my Case and don’t have time to rest too , busy busy and busy. So today i have 4 hour to rest before back to my routine work again this a little update , i just finish my Case handle.
Case handle
Part XI
Just done new foot base of my case and after waiting for RMA part and it still not in progress , so i decide to sell my other part that still working and bought new one. A little custom mod of my new motherboard to add heatsink to chip. See picture below.
Foot base
Custom chip heatsink
Part XII
Again, Black to work just add led light to my case , not much better design just need the light. And now just finish 8 fan setup and it quiet by using huge resistor.
Led light
After setup
Part XIII
Just put Spindle inverter to my Case and it will close to finish soon , Still need to custom font panel both left and right.
All in Case
Part XIV
Hello, Long time nothing update agian, so now just finish my right font side panel. Not much description let’s see picture.
Right Font Panel::
Part XV
Back to work with left panel , not many thing to do but a little take time and now my Custom case finish but not 100% i still need to do more wiring and need to use aluminum slot cap to put it in slot by using back color slot cap and will update after finish the slot cap.
Aluminum for hold acrylic
Put it in Case
Start cutting acrylic for font left panel
Finish cutting and put it in
Finish
Long time nothing update again, i just busy for moving to new condo and other work so busy. So today i need to update the final picture of my CNC & PC Enclosure.